TVBGone/en

Aus Wiki CCC Göttingen
Zur Navigation springen Zur Suche springen
TVbgone with two SMD LEDs and two normal 5mm LEDs

This is a clone of the normal TVBGone Kit. TVBGone is a board, that tries to switch off every TV device. This one is build with almost only SMD parts, this board is smaller than the original.

PCB

P1:

1 - Reset

2 - GND

3 - Vcc

4 - SCK

5 - MISO

6 - MOSI

P2:

1 - Vcc

2 - GND


BOM

Necessary

Designator Value Part-No Price / EUR Count Sum / EUR
R1 1 kΩ, 0805 R: 0.01 1 0.01
R3 10 kΩ, 1206 R: 0.01 1 0.01
R5 470 Ω, 0603 R: 0.01 1 0.01
C1 100nF, 0603 C: 0.01 1 0.01
C2 100uF 100uF,1206 0.34 1 0.34
C3, C4 22pF 0603 C: 0.01 2 0.02
T1, T2, T3, T4 NPN SOT23 BC817 0.04 4 0.16
T5 PNP SOT23 BC807 0.04 1 0.4
XTAL1 8Mhz hc49 Q 8 MHZ HC 49/US-SMD 0.26 1 0.26
LED5 yellow 0603 0.01 1 0.01
uC micro controller SOIC ATTINY85V-10SU 1.95 1 1.95
P1, P2 plug connector 6 Pol, 2 Pole 0.24 1 0.24
S1 switch ? 1 ?
Sum 2.86

Infrared LEDs

The perfect LEDs aren't found till now. The SMD LEDs have a too big opening angle, so the power is not enough for switching the TV off. On the other hand with 10° you have to target very perfectly... Another problem is that the board haas a bug for the SMD LEDs, if these are solded, they can create a short circuit, but this will be fixed for the next version.

Designator Value Part-No Price / EUR Count Sum / EUR
LED1, LED2, LED3, LED4 side LED 950nm,60° Q65110A2463 0.35 4 1.40
LED1, LED2, LED3, LED4 5 mm, 950 nm, 10° Q62703Q1820 0.27 4 1.08