3D-Drucker/Aufbau 1

Am 3.-4.12.2011 waren Alex und HW in Köln in der DingFabrik zum Aufbauworkshop

Post von Klement (Workshop-Leiter) vom 20.12.2011

Dieses Config-File ist von Klement für den Workshop Drucker entstanden

bottom_layer_speed_ratio = 0.6
bridge_flow_ratio = 1
bridge_speed = 60
duplicate_distance = 6
duplicate_x = 1
duplicate_y = 1
end_gcode = M104 S0 ; turn off temperature\nG28 X0  ; home X axis\nM84     ; disable motors
extrusion_axis = E
extrusion_multiplier = 1
extrusion_width_ratio = 0
filament_diameter = 3
fill_angle = 45
fill_density = 0.2
fill_pattern = rectilinear
first_layer_height_ratio = 1
g0 = 0
gcode_arcs = 0
gcode_comments = 0
infill_every_layers = 1
infill_speed = 60
layer_height = 0.15
nozzle_diameter = 0.5
perimeter_speed = 30
perimeters = 3
print_center = 100,100
retract_before_travel = 2
retract_length = 1
retract_lift = 0
retract_restart_extra = 0
retract_speed = 30
rotate = 0
scale = 1
skirt_distance = 6
skirt_height = 1
skirts = 1
small_perimeter_speed = 30
solid_fill_pattern = rectilinear
solid_infill_speed = 60
solid_layers = 3
start_gcode = G28 ; home all axes
temperature = 175
travel_speed = 130
use_relative_e_distances = 0
z_offset = 0