Schliesssystem

Schema

{Laptop,Handy,Tablet} <-> WRT <-> ethernet GPIO device <-> {Keymatic, Sprechanlage}

DING

mode

doorctl mode set [mode]

This command controls the door mode. Possible parameters are:

• locked
• unlocked
• unlocked+ert

Aside from this command, you can cycle through modes by pressing the pushbutton on the DING. When switchng between locked an one of the unlocked*-modes, the door is locked or unlocked, respectively.

Pinout

• relais 1: keymatic.close
• relais 2: keymatic.open
• relais 3: siedle.open

Connector pinout

These are the pinouts of the two flat cables coming from entryphone and keymatic.

Siedle entryphone

• Pin 1: door opener connector a
• Pin 2: door opener connector b
• Pin 3: ERT connector a
• Pin 4: ERT connector b
• Pin 5-10: not used

Keymatic

• Pin 1: Pushbutton lock/unlock (?)
• Pin 2: Pushbutton common
• Pin 3: Pushbutton lock/unlock (?)
• Pin 4: RI common
• Pin 5: RI dooropener
• Pin 6: RI lock/unlock (?)
• Pin 7: RI lock/unlock (?)
• Pin 8: unused
• Pin 9: RI power supply
• Pin 10: RI power supply

Todo

• neuen Schliesszylinder installieren
• GPIO device installieren
• keymatic verkabeln und an GPIO device anschliessen
• sprechanlage an GPIO device anschliessen
• auth-system
• netzwerkconfig
• GPIO-Device korrekt aufhaengen
• Gemeinsame Stromversorgung
  • Fritzbox (?)
  • brickme (?)
  • Keymatic (12V)
  • DING (5V)
  • Telefon (?)
• Tuermagnet
• Temperatursensor
• Stromzaehlerleser