Soldering Workshop: Unterschied zwischen den Versionen

Aktuelle Version vom 15. November 2011, 17:04 Uhr

The most kits we create and solder employ SMD (Surface Mount Devices, in contrast to Through Hole Devices (THD or THT with s/Devices/Technology/)) parts. SMD soldering is not so different than the THT soldering which is more common to hobbyists. The biggest difference is, that the parts are smaller and instead of applying solder to perpendicular areas, the areas are mostly parralel and directly adjacent. Thus the soldering technique is quite different. In our workshop, we will explain how to solder SMD parts.

The solder we usually use contanis lead and some (mostly weak) acid. Thus each place should be covered with newspaper. When taking a break of cleaning up afterwards, one should wash hands.

Recommended Skills[Bearbeiten]

calm hands
some soldering experience would be helpful, but generally not required.

Hardware[Bearbeiten]

Soldering[Bearbeiten]

per Person[Bearbeiten]

Soldering unit
tweezer
tin solder

per Group of 2-5[Bearbeiten]

desoldering braid
soldering flux (fluid or solid)
side cutter
desoldering unit

room[Bearbeiten]

newspaper
enough light

Testing[Bearbeiten]

Oszi
Multimeter
Power station

Programming[Bearbeiten]

Programmer
Programmer cable
Power station

@@ Zeile 1: / Zeile 1: @@
 go to the [[Lötworkshop|german version]].
-The most kits we create and solder employ SMD (Surface Mount Devices, in contrast to Through Hole Devices (THD or THT with s/Devices/Technology/) parts. SMD soldering is not so different than "normal" soldering. The most diffrence, that the parts are smaller. So the kind of soldering is diffrent. In our workshop, we explain how to solder SMD parts.
+The most kits we create and solder employ SMD (Surface Mount Devices, in contrast to Through Hole Devices (THD or THT with s/Devices/Technology/)) parts. SMD soldering is not so different than the THT soldering which is more common to hobbyists. The biggest difference is, that the parts are smaller and instead of applying solder to perpendicular areas, the areas are mostly parralel and directly adjacent. Thus the soldering technique is quite different. In our workshop, we will explain how to solder SMD parts.
-We use plumb containing solder, eache place should be covered with f. ex. newspaper. After stopping soldering, hands should be cleaned.
+The solder we usually use contanis lead and some (mostly weak) acid. Thus each place should be covered with newspaper. When taking a break of cleaning up afterwards, one should wash hands.
-==Precognition==
+==Recommended Skills==
-* clam hands
+* calm hands
-* soldering experirience (good to have, but not nessasary)
+* some soldering experience would be helpful, but '''generally not required'''.
 ==Hardware==
@@ Zeile 16: / Zeile 16: @@
 * tin solder
-====per 2-5 Persons====
+====per Group of 2-5====
 * desoldering braid
 * soldering flux (fluid or solid)